Hitachi CB 520H A1 - Page 383

Message Content
LP-Loader detected Emulex Multi Channel mode (Bus:0xXX,
Dev:0xYY, Fnc:0xZZ), which is not supported. Please
disable Emulex Multi Channel mode.
XX: Bus number
YY: Device number
ZZ: Function Number
Explanation LPAR manager cannot boot due to the Enabled multiple channel
support of Emulex NIC.
What to do Set "Multichannel Support" as <Disabled>.
See the Hitachi Compute Blade Emulex Adapter User's Guide for
Hardware for setting it.
However, it cannot be changed in LP mode. If necessary, change
it in Basic mode.
Message Content
LP-Loader detected invalid configuration files.[version is
unmatched]
(ErrorCode:XXXXXXXXXXXXXXXX
AdditionalCode:XXXXXXXXXXXXXXXX)
Please Power Off Partition.
Explanation LPAR manager cannot boot due to the file with incorrect
configuration information.
What to do Restore a file with a correct configuration information.
Message Content
LP-Loader detected invalid Virtualization Technology
setting in this system.
MSR INFO [0xXXXXXXXXXXXXXXXX]
Please set Virtualization Technology setting to enable.
Explanation LPAR manager cannot boot due to the Disabled Virtualization
Technology Setting.
What to do Set Enable in Virtualization Technology Setting using the EFI
setup menu.
For details about the setup method, see the Hitachi Compute
Blade 500 series EFI User's Guide.
Message Content
LP-Loader detected OEM FRU was unsupported version.
(ver:XXXX)
Explanation Unsupported FRU version was detected.
What to do Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message Content
LP-Loader detected VfcSeed.dat format error.(Error Info:
0xXXXX)
Explanation The incorrect format is detected on VfcSeed.dat file, having the
Vfc seed information, and the N+M cannot be performed.
XXXX: cause
Messages
9-7
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide