Message Content Failed to save LP configuration
What to do Check the Internal Path State on the system service state screen.
If Link is shown as No or Connect as Fail, check the internal LAN
switch settings.
Message Content Go to Shared FC Assign on Type=F & Schd=S.
Explanation The device is a shared FC, so you need to change it on the
Shared FC Assignment screen.
LPAR manager
operation
Aborts the specified process.
What to do Make the setting on the Shared FC Assignment screen.
Message Content Go to VNIC Assign on Type=N & Schd=S.
Explanation The device is a shared NIC, so you need to change it on the
Virtual NIC Assignment screen.
LPAR manager
operation
Aborts the specified process.
What to do Make the setting on the Virtual NIC Assignment screen.
Message Content
Guest operating system may not remove USB device(s)
safely. Force to detach.
Explanation Indicates that connecting or disconnecting the device has failed.
LPAR manager
operation
If activating the LPAR, stops activation. If changing the device
target, stops connecting or disconnecting the device.
What to do Assign the USB device to the LPAR again.
Message Content LP cannot activate LPAR due to safe mode.
Explanation The LPAR cannot be activated because the safe mode is on.
LPAR manager
operation
Aborts the specified process.
What to do Release the safe mode and then perform the operation again.
Message Content LP cannot save configuration due to safe mode.
Explanation The configuration information cannot be saved because the safe
mode is on.
LPAR manager
operation
Aborts the specified process.
What to do Release the safe mode and then perform the operation again.
Messages
9-13
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
