Message Content NTP server is not set.
LPAR manager
operation
Stop a time-getting of NTP server
What to do Set the IP address of a NTP server to NTP Server 1 or NTP server
2.
Message Content
NUMA configuration error.
Set processor scheduling mode to dedicated and bind
logical processor to physical processor manually.
Explanation The guest NUMA configuration is invalid.
Set the scheduling mode of the processor to dedicated mode, and
then allocate a physical processor to the logical processor.
LPAR manager
operation
Aborts the specified process.
What to do Set the scheduling mode of the processor to dedicated mode, and
then allocate a physical processor to the logical processor.
Message Content
Operation failed because system configuration is being
updating.
Explanation The operation was not accepted because the LPAR manager
configuration information is now being saved.
LPAR manager
operation
Aborts the specified process.
What to do Wait a while, and then retry the specified process.
Message Content Over Max VLAN ID count (16).
Explanation The number of the specified VLANID exceeds 16.
LPAR manager
operation
Either automatically modifies the number of specified VLANID to
be less than 16, or keeps the message sub-screen on the terminal
display until ESC key is pressed.
What to do Change the number of VLANID to be less than 16, or cancel the
VLANID setting operation by pressing ESC key.
Message Content Over the maximum number of activated LPARs (X).
Explanation The LPAR cannot be activated because it is beyond the max
number (X) of LPARs to activate with Essential model, Advanced
model, and Enterprise model.
LPAR manager
operation
Aborts the LPAR activation.
What to do Deactivate an LPAR currently activated, and then activate the
LPAR again.
9-20
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
