Hitachi EH-150 Series - Page 155

Chapter 7 System setup
7 - 11
 The solution for each error code
Table 7.5 The solution for each error code
No
Return
code
Name
Solution
1
(None)
Watch dog timer error
Please eliminate the source of a noise, reboot on a power supply, and see
2
HFFxx
CPU error
a situation.
3
H01xx
ROM error
4
H02xx
RAM error
5
H03xx
OS system error
6
H21xx
Range check error
Please check s parameter.
7
H22xx
Sending data area setting
error
Please check s parameter. (designation of sending data area)
8
H23xx
Sending data area range
error
9
H24xx
Receiving data area setting
error
Please check s parameter. (designation of receiving data area)
10
H25xx
Receiving data area range
error
11
H28xx
Area overlap error
Please check whether there is any overlap in s parameter, t parameter,
sending data area, and receiving data area.
12
H30xx
Command time-out error
Please enlarge time of the command timeout of s parameter.
13
H40xx
Receiving data overflow
Please enlarge send data area size of s parameter.
14
H50xx
Designated Invalid
command
Please check the command of s parameter.
15
H51xx
Number of entries over
Please make into less than 8 sets the number of EH-SIO currently operated
in Modbus slave mode, Hi-Protocol mode, Simple data link mode.
* When at least less than eight sets of this error come out, please once turn
off a power supply.
16
H81xx
Command not-supported
Please check the command of s parameter.
17
H82xx
Initial setting error
Please check whether initial setting of a port has ended.
18
H83xx
Transmission data error
Please check whether it is satisfactory to the value stored in sending data
area.
19
H84xx
Receive buffer full
Please execute the read command and read the data of a receiving buffer.
20
H85xx
Connect error
Please check the state of the control signal of external apparatus and
connection of a connection cable.
21
H8Axx
Parity error
Please check a setup of DIP Sw.
22
H8Bxx
Framing error
23
H8Cxx
Overrun error
24
H8Dxx
Check code error
Please check the pattern of a check code and message code configuration.
25
H8Exx
Timeout error (Receive)
Please enlarge receiving timeout time designated by initial setting.
26
H8Fxx
Timeout error (Send)
Please check the state of the control signal of external apparatus and
connection of a connection cable.
27
H90xx
Error message reception
The exception response returned from Modbus slave device. Please check
the parameter and data of send data area which are send as query.
28
H91xx
Message data error
Please check the send data of send data area. Moreover, please check the
character (Binary, ASCII) of the data sent from external device.
29
H92xx
Designated query error
(Modbus mode)
Please check the parameter (the number of data to read and the number of
send data bytes) of send data area which send as query.
« Note »
Priority of parity error, framing error and overrun is as follows.
Parity error > Framing error > Overrun error