Hitachi EH-150 Series - Send Query, Receive Response

Chapter 6 Communication Mode
6 - 35
Modbus Master
6.3.4 Send Query, Receive Response
 The TRNS 9 command s-parameter at time of query transmission
Command (specified as s+7) of query sending is H0080
Figure 6.27 s parameter format (Modbus master / Query transmission)
 Execution of query transmission
After setting each parameter in Fig. 6.27 to s parameter area and storing the query parameter in the sending data
area, please turn ON the command execution flag (t+0). (The format of the query data area depends on function
code.)
 Response receiving
Response data is automatically stored receiving data area with completion flag being ON. (In modbus master mode,
one cycle of TRNS 9 command is from sending to receiving.)
When any errors from the slave response are detected or an exception response is returned, an error flag (t+2) turns
on. The exception response data (exception code) is stored in the receiving data area.
« Note »
EH-SIO checks the validity of the response code, the function code, and the check code only. Therefore, if the
above-mentioned item is correct, the data are stored in receiving data area even if more data than requested is
received.
Top I/O address of
receiving data area
Size of receiving data area
Return code
H 0 0 8 0 (Command)
Command timeout time
Top I/O address of
sending data area
s
s+7
s+8
s+9
s+B
s+D
For sending query.
System area (6 words)
The command at the time of query transmission is H0080.
The execution result of TRNS 9 command is displayed.
(Set by the system.)
For response data.