Error code
(SSB2)
Description
C22A The command was rejected because the pair release was run on a volume other than P-
VOL.
C22C The command was rejected because the volume is unpaired.
C22D The command was rejected because the specified volume is the volume other than the
P-VOL.
C22E The command was rejected because the pairsplit command specifying -P option (write
protection of P-VOL) was issued to a volume whose status is not PAIR.
C233 The command was rejected because the S-VOL status is unpaired.
C234/C235/
C236/C237
The command was rejected because an internal logical error has occurred.
C238 The command was rejected because the specified volume is the volume other than the
P-VOL.
C239 The command was rejected because the pair resync was operated on a volume whose
status is other than PSUS (by user) PSUS (because of failure).
C23A The command was rejected because an internal logical error has occurred.
C23B The command was rejected because the volume is unpaired.
C23C The command was rejected because the volume status is other than PAIR or COPY.
C23D The command was rejected because the command for TC asynchronous was issued to
the TC asynchronous volume.
C267 The pair cannot be created because the command was issued to the command device.
C271 The command was rejected because the specified consistency group ID is invalid.
C28B The command was rejected because the takeover command was issued to a volume
whose status is not SSWS.
C28C The command was rejected because the secondary system is not registered, or the
registered information is invalid.
C28D There is no volume to which the takeover command can run.
C28E The command was rejected because an internal logical error has occurred.
C297 The command was rejected because the specified volume is used as an S-VOL.
C2A0 The pair cannot be created because the capacity that is used by software products other
than TC exceeds license capacity.
C2A1 The command was rejected because an internal logical error has occurred.
C2A3 The pair cannot be created because the used capacity exceeds the license capacity.
C2B3 The command was rejected because DP-VOL capacity is changing.
C2B4 The command was rejected because an internal logical error has occurred.
C2B5 The pair cannot be created because the TC P-VOL is being initialized by ShadowImage.
C2B6 The command was rejected because the releasing pages in DP-VOL is in progress.
C300 The TC pair associated with a UR pair cannot be created because the Remote
Replication Extended program product is not installed on the primary system.
Troubleshooting
10-9
Hitachi TrueCopy® User Guide for Hitachi Virtual Storage Platform Gx00 and Fx00 Models
To Next Page
Loading...
