Hitachi G200 - SSB2 Error Codes When SSB1 = B90 B; SSB2 Error Codes When SSB1 = B912; SSB2 Error Codes When SSB1 = B980; Service Information Messages (Sims)

SSB2 error codes when SSB1 = B90B
Error Code
(SSB1)
Error Code
(SSB2)
Description
B90B B9E0 The command was rejected because the function for deleting pairs forcibly is
not supported.
SSB2 error codes when SSB1 = B912
Error Code
(SSB1)
Error Code
(SSB2)
Description
B912 B96D The command was rejected because the volume status is SMPL.
SSB2 error codes when SSB1 = B980
Error Code
(SSB1)
Error Code
(SSB2)
Description
B980 B901 The command was rejected because the specified port is for NAS Platform
(system LU).
B980 B903 The command was rejected because the selected resource belongs to
NAS_Platform_System_RSG.
Service Information Messages (SIMs)
The VSP G200, G400, G600, G800 and VSP F400, F600, F800 storage
systems generate a service information message (SIM) to notify users of a
possible service requirement for the storage system. SIMs can be generated
by the system's channel and storage path microprocessors or the service
processor (SVP). The SVP reports all SIMs related to TrueCopy operations.
All SIMs are recorded on the SVP and displayed in the Alert tab of the Device
Manager - Storage Navigator Storage System window.
For more information, see the System Administrator Guide for Hitachi Virtual
Storage Platform Gx00 and Fx00 Models.
During TrueCopy operations, the primary and secondary systems generate a
service SIM when P-VOL or S-VOL pair status changes for any reason,
including normal status transitions (for example, COPY to PAIR).
• SIMs generated by the primary system include the P-VOL device ID (byte
13).
• SIMs generated by the secondary system include the S-VOL device ID
(byte 13).
If SNMP is installed and operational on the storage system, each SIM results
in an SNMP trap being sent to the appropriate hosts.
Troubleshooting
10-17
Hitachi TrueCopy® User Guide for Hitachi Virtual Storage Platform Gx00 and Fx00 Models