6-13 ●How to correct ink stream bending and nozzle clogging
6A00123
(d) Remove the nozzle orifice once and make sure
that the O-ring has been installed.
(e) Remove the nozzle orifice, and use the four
screws to secure it.
● Use the four screws to secure the nozzle orifice so that
the characters on it face up.
● Tighten the four screws little by little alternately.
(f) Reinstall the charge electrode and deflection
electrode.
Press the Ink stream alignment → Start/Continue and confirm that bending of
the stream and clogging of the nozzle have been repaired.
● Perform this operation with the tip of the print head inserted into a beaker.
● When the ink stream is way outside the gutter, cleaning of the nozzle orifice may not be sufficient.
Disassemble and clean the nozzle orifice again.
● When the ink stream position has deviated from the center of the gutter, adjust it in accordance
with par. “6.5 Stream alignment”.
4
O-ring
Attach to the groove
Characters
Charge electrode
Nozzle orifice
Upper
Lower
To Next Page
Loading...
