●Replacing the ink filter 6-20
2015.07.0712:45
Com=0
Ink Drainage
Filter rep.
Ink refill
Process：Ink filter replacement
Confirm the ink filter is set at the right position.
Press [Start/Continue].
Operation guide
Abort
Start/Continue
Circulation control [Service ]
(b) Set the ink filter as follows. (Piping joints D is on the right.)
(c) Fill the reservoir with new ink.
(d) Insert the tip of the print head into a beaker.
● Prepares for bending of the ink stream.
Refill the IJ printer with ink
● When Start/Continue is pressed on the screen shown below, refilling of the lines with ink
begins.
● After a while, ink is ejected from the nozzle. Check the position of the ink stream.
4
● To abort the sequence, press the Abort key, and follow the on-screen instructions.
After aborting, you are returned to the "Circulation control" screen.
● When you have aborted the sequence, select the "Ink refill" from the "Circulation control"
screen and perform it.
● If the following message is output during ink refill, the system will automatically stop.
"Failure was detected in level sensor, pump or solenoid valve.
When ready, press Start/Continue ."
Press Start/Continue key, select "Ink refill" on "Circulation control" screen and execute refill.
If the same message appears again, contact your nearest local distributor.
Piping joints(D)
Ink filter
To Next Page
Loading...
