6-19 ●Replacing the ink filter
2015.07.0712:45
Com=0
Ink Drainage
Ink rep.
Ink refill
Process：Ink filter replacement
Replace ink filter with a new one.
Put ink into the ink reservoir.
When ready press [Start/Continue].
Operation guide
Proc. status:
Abort
Start/Continue
Circulation control [Service ]
Use ink filter
New ink filter
C D
C D
C D
C D
Piping joints C
Piping joints D
Lock release
［Connect piping joints］
［Disconnect piping joints］
When the operation guide “Replace ink filter -----” is displayed, replace ink
filter with a new one.
3
(a) Disconnect piping joints C and D and connect them to a new ink filter.
The joints cannot be installed if the installation position of the piping is incorrect.
(C is at the center of the ink filter and D is at the outside.)
When installing, always lock piping joints C and D by turning them clockwise.
A small amount of ink will remain inside the ink filter even after ink drainage.
Be careful that the ink does not spill when handling the used ink filter.
CAUTION
2
1
3
To Next Page
Loading...
