Hitachi IJ RX2 - Page 161

●Long-term Shutdown 6-38
Circulation control
Select option; press [Start/Cont.] Proc. status:
2015.07.0712:45
Com=0
[Stop ]
Eject ink
(Goes to Standby)
Cleaning stop No-cleaning stop
Nozzle backwash
Recovery-line
cleaning
Ink replacement
Ink filter
replacement
Ink circulation
Cancel
Start/Continue
HOME
Prev.Dsp.
NextDsp.
Process prior to
long-term shutdown
Process after
long-term shutdown
Makeup refill
(e) Open the "Circulation control" screen, and press the Ink stream alignment key and
then the Start/Continue key.
● Check if the ink stream is going into the gutter and it’s in the center of the gutter.
● Check whether the gutter absorbs the liquid.
If the ink is not being ejected, press Ink stream alignment key again. An ink fixing may
be caused if the ink is not ejected after Ink stream alignment is conducted two times.
An ink fixing may be caused if the suction of the liquid.
A special work is required for restoration. Contact your local distributor.
If the "Ink steam bending" occurs, refer to Technical manual "6.4 How to correct ink
stream bending and nozzle clogging" for restoration. If the ink stream bending is not
corrected, a special work is required. Contact your local distributor.
CAUTION
(a) Open the "Circulation control" screen, and press the
Process after long-term shutdown key then the Start/Continue key.
Start/Continue
(b) Follow the on-screen instructions for the operation.
● Repeat twice the same procedure as in "6.3 Replacing the ink".
(c) At the end of operation, screen returns to the Circulation control screen.
Put the end of print head into the beaker then press Ink refill key and Start/Continue
key. The ink will be ejected in a few minutes.
If the ink does not eject after pressing Ink refill key and Start/Continue key or "Ink
pressure low" or "No ink drop charge" is displayed, a special work is required for
restoration. Contact the local distributor near you.
CAUTION
Operating procedure- "Process after long-term shutdown"
2