Hitachi UX2 - Page 66

65
Error Code Table (1/2)
Error
Code
Name
Description
Check
001
Transmission code
error
●
The transmitted code was not defined
for communication use.
●
The transmitted message had an
illegal structure.
Check the baud rate and transmission code.
002
Print specifications
code error
The print specifications data value was
illegal.
Check the print specifications
Communication text.
003
Print character
code error
More than 1000 characters for one item
were sent.
Check the printings communication text.
004
Item number
error
The item number code value was illegal.
Check the printings communication text.
005
Header error
The header value was illegal.
Check the header.
006
Ready-for-reception
error
●
An attempt was made to establish
communication while the "not ready for
reception" state prevailed.
●
"Off-line fixed" has been set in
communication environment.
●
Communication monitor screen was
displayed.
●
Communication was conducted during
the stop or shutdown process.
Check the transmission timing.
008
Print specifications
code error
The maximum value was exceeded by
the print specifications data.
Check the print specifications
communication text.
009
ETX code error
The ETX code position was illegal.
Check the transmission procedure and
ETX code.
010
DLE code error
The DLE code position was illegal.
Check the transmission procedure and
DLE code.
011
STX code error
The STX code position was illegal.
Check the transmission procedure and
STX code.
012
ENQ code error
The ENQ code position was illegal.
Check the transmission procedure and
ENQ code.
013
ESC code error
(ESC, ESC2)
The ESC code position was illegal.
Check the transmission procedure and
ESC code.
015
Print format
code error
The print format data value was illegal.
Check the print format transmission text
section.
017
Framing error
The framing error occurred.
Check the baud rate and data format.
019
2-byte code error
●
An illegal 2-byte code (2bytes per character)
was transmitted.
●
Only one byte of 2-byte code was
transmitted.
Check the 2-byte code transmission text.
020
Print data
code error
●
The print data registration number was
illegal.
●
An unregistered number was encountered.
Check the print data recall / transmission
code.
021
SI, SO code error
The SI (shift in) or SO (shift out) code position
was illegal.
Check the printings communication text.
022
User pattern
character size/
character code error
The character size or character code values
were illegal.
Check the user pattern communication text.
023
High-speed
printing setup error
When necessary conditions for high speed
printing were not satisfied, NM, QM, SM, or
D1 mode was transmitted.
Check the print specifications
communication text.