ROUTINE OPERATION
90
B-Channel Hands-Free (BHF) Mode:
By default, this setting is OFF for B button. Press the B button once to communicate with other
headsets, remaining hands-free to perform other tasks. Press the B button to disconnect.
h Turn Mode ON: With the headset power OFF, simultaneously press and hold the B
button and A2 and then press the Power button. Once the power is on, release B and
A2.
h Turn Mode OFF: With the headset power OFF, press and hold the B button and A2 and
then press the Power button. Once the power is on, release B and A2.
A voice prompt in the headset will say “Headset #, Battery Full/Half/Low, B Hands Free On/Off,
Lane #”.
See Section 8.5, pg. 92, for more information on BHF mode.
Push-To-Talk (PTT) Mode:
By default, this setting is OFF. Press and hold the A button to connect and speak to a customer.
Release the A button to disconnect from the customer.
h Turn mode ON: With the headset power OFF, simultaneously press and hold the B
button and the Down arrow (V) and then press the Power button. Once the power is on,
release B and (V).
h Turn mode OFF: With the headset power OFF, simultaneously press and hold the B
button and the Up arrow (Λ) while you press the Power button. Once the power is on,
release B and (Λ).
A voice prompt in the headset will say “Headset #, Battery Full/Half/Low, A Hands Free On/Off,
Lane #”.
● Headset alert tone(s) signals arrival at the speaker post or menu board (single beep for
Lane 1, double beep for Lane 2).
● Use the Λ and down V buttons to adjust volume.
● Touch and hold the A1 button (Lane 1) or A2 button (Lane 2) to speak to a customer.
Release to stop speaking to the customer (full duplex) or to listen to the customer (half
duplex).
See Section 1.1, pg. 1, for more details on Duplex Modes.
To Next Page
Loading...