17
2.1 Stripe Hog System Introduction
The SH8000 waterblasting system is mounted
to the truck chassis and powered by the truck
engine through a special power take o. The
waterblasting system includes an Ultra-high pres-
sure water system, vacuum system, water and
debris tanks, hydraulic system, hydrostatic drive
system and DC electrical system.
Most components are controlled by switches in a
cab mounted control switch panel, Joystick console
and PLC screen. Others are controlled by switches
or switch panels located on the chassis near the
component controlled by the switch or switches.
The operation and maintenance requirements for
the engine, drive train and chassis components
are unique to the manufacturer and the selected
options. Each truck chassis manufacturer provides
owners information manuals with their product.
It is important that you read the manuals care-
fully and become familiar with the proper care
and operation of engine, drive system, chassis,
safety equipment and all components of your
truck chassis.
2.2 Ultra-high Pressure Water System
Each manufacturer of the high pressure
waterblasting system components provides an
information and operating manual with its prod-
uct. It is extremely important that you read the
manuals and become familiar with the proper care
and operation of the components before operating
the waterblasting system.
HIGH PRESSURE WATER FROM SPRAY JETS OR RUPTURED
HOSES CAN CAUSE SEVERE INJURY OR EVEN DEATH.
ALWAYS BE SURE WORK AREA IS CLEAR OF PEOPLE,
HANDS, FEET, ETC., BEFORE ENGAGING THE 40K CLUTCH
SWITCH TO ACTIVATE THE ULTRA-HIGH PRESSURE
SYSTEM.
Section 2:
Stripe Hog Systems
To Next Page
Loading...
Need help?
General