90
Operation
3.6 Dumping Debris Procedure
1. Be sure you are dumping in an approved dump
site and that the truck is on solid, level ground.
2. Preform the Startup Procedure to place the
truck in OPERATE MODE which will activate
the hydraulic system.
3. Drain all water from the debris tank by mov-
ing the Debris Tank switch to the OPEN DRAIN
position. Allow the tank to completely drain
then close the drain valves.
4. Plug the hand remote control in to the grey
receptacle next to the debris tank control
switch panel.
5. Move the Door Seal switch on the debris tank
control panel to the DEFLATE position to
completely deate the air seal on the debris
tank door.
6. Move the Door switch on the control panel to
the ON position to activate DOOR CONTROL
MODE on the remote control. Then press the
DOWN button on the remote to close the door
slightly to remove pressure on the latch pawls.
Turn the Door switch OFF.
REMOTE CONTROL
RECEPTACLE
Debris Tank Control Switch Panel &
Remote Control Receptacle
Hydraulic Door Latch Open
To Next Page
Loading...
Need help?
General