84
Operation
8. Select “D”, (Drive), on the truck transmission
after the red light is lit. Wait until 4 4 is dis-
played on the transmission LED.
9. When 4 4 is displayed, the truck has been
successfully shifted into Operate Mode and
is ready for the operator to activate the
waterblasting system.
B. Startup procedure to engage Operate
Mode on trucks with a manual transmission:
1. Make sure all switches and speed dials are in
the OFF position or set at 0.
2. Be sure the truck transmission is in “N”, (NEU-
TRAL) position and the park brake is set.
3. Start truck engine and allow it run at idle
speed.
4. Press and hold the clutch pedal and brake
pedals. Then release the park brake.
5. Verify the green Drive Mode LED light is lit.
6. Make sure the truck is not moving, then turn
the console PTO switch ON and listen for the
PTO to engage. Wait 10 seconds for the green
Drive Mode light to go OFF and the red Operate
Mode light to turn ON.
Typical Manual Transmission
START UP/SHUT DOWN PROCEDURE Placard On Visor
Drive Mode Indicator LED Lights
7. With the clutch pedal still depressed and the
engine at idle, shift the transmission to the
gear stated in the startup instructions on the
visor placard.
8. Slowly release the clutch to engage the trans-
mission and Operate Mode drivetrain.
9. The truck has been successfully shifted into
Operate Mode and is ready for the operator to
activate the waterblasting system.
To Next Page
Loading...
Need help?
General