Holtek HT66F0175 - Page 196

Rev. 1.50 196 August 28, 2017 Rev. 1.50 197 August 28, 2017
HT66F0175/HT66F0185
A/D Flash MCU with EEPROM
HT66F0175/HT66F0185
A/D Flash MCU with EEPROM
RRA [m]
RotateDataMemoryrightwithresultinACC
Description DatainthespeciedDataMemoryandthecarryagarerotatedrightby1bitwithbit0
 rotatedintobit7.TherotatedresultisstoredintheAccumulatorandthecontentsofthe
 DataMemoryremainunchanged.
Operation ACC.i←[m].(i+1);(i=0~6)
 ACC.7←[m].0
Affectedag(s) None
RRC [m]
RotateDataMemoryrightthroughCarry
Description ThecontentsofthespeciedDataMemoryandthecarryagarerotatedrightby1bit.Bit0
 replacestheCarrybitandtheoriginalcarryagisrotatedintobit7.
Operation [m].i←[m].(i+1);(i=0~6)
 [m].7←C
 C←[m].0
Affectedag(s) C
RRCA [m]
 RotateDataMemoryrightthroughCarrywithresultinACC
Description DatainthespeciedDataMemoryandthecarryagarerotatedrightby1bit.Bit0replaces
 theCarrybitandtheoriginalcarryagisrotatedintobit7.Therotatedresultisstoredinthe
 AccumulatorandthecontentsoftheDataMemoryremainunchanged.
Operation ACC.i←[m].(i+1);(i=0~6)
 ACC.7←C
 C←[m].0
Affectedag(s) C
SBC A,[m]
 SubtractDataMemoryfromACCwithCarry
Description ThecontentsofthespeciedDataMemoryandthecomplementofthecarryagare
 subtractedfromtheAccumulator.TheresultisstoredintheAccumulator.Notethatifthe
 resultofsubtractionisnegative,theCagwillbeclearedto0,otherwiseiftheresultis
 positiveorzero,theCagwillbesetto1.
Operation ACC←ACC−[m]−C
Affectedag(s) OV,Z,AC,C
SBCM A,[m]
 SubtractDataMemoryfromACCwithCarryandresultinDataMemory
Description ThecontentsofthespeciedDataMemoryandthecomplementofthecarryagare
 subtractedfromtheAccumulator.TheresultisstoredintheDataMemory.Notethatifthe
 resultofsubtractionisnegative,theCagwillbeclearedto0,otherwiseiftheresultis
 positiveorzero,theCagwillbesetto1.
Operation [m]←ACC−[m]−C
Affectedag(s) OV,Z,AC,C
SDZ [m]
SkipifdecrementDataMemoryis0
Description ThecontentsofthespeciedDataMemoryarerstdecrementedby1.Iftheresultis0the
 followinginstructionisskipped.Asthisrequirestheinsertionofadummyinstructionwhile
 thenextinstructionisfetched,itisatwocycleinstruction.Iftheresultisnot0theprogram
 proceedswiththefollowinginstruction.
Operation [m]←[m]−1
 Skipif[m]=0
Affectedag(s) None