BF15DoBFZOD
4)
Push the
"UP"
side of the power tilt switch and extend the
piston rod fully.
5) Remove the special tool and pressure gauge from the
valve body Install the sealing washer, manual valve and
the internal circlip in the valve body
lN-1
Be sure to remove the special tool with the piston rod
fully extended, or the
ATF
spurts out.
A
small amount of the
ATF
flows
out
after removing
the tool. Install the manual valve quickly.
Install the sealing washer securely not
to
let it collapse
in the valve body.
6)
Tighten the manual valve to the specified torque.
TORQUE:
1.7
N*m
(0.17
kgf-m,
1.2
Ibf-ft)
7)
With the piston rod fully extended, check whether the
ATF
level
is
at the edge
of
the filler port of the oil tank
(P.
13-55).
If
the oil level is low, add the fluid
(ATF)
up to the
edge of the filler port.
8)
Install the power tilt assembly (P. 13-39).
11
PI
\
MANUAL VALVE
rsl
07OPJ-Vl50100
141
PRESSURE GAUGE
(Commercially available)
12-43
To Next Page
