Honeywell Home T10 - EIM Wiring to Hot Water Relay Panel; EIM Wiring to TrueZONE Panel (Conventional Heat)

33-00462—05 20
Fig. 41. Typical wiring EIM to a hot water relay panel
Fig. 42. Typical wiring EIM to a Resideo TrueZONE forced air zone panel for conventional heat
R
C
AUX1
AUX2
24 VAC TO
THERMOSTAT
THM04R3000
Y2
G
L
W1
W2
W3
Y1
RH
RC
R
C
24 VAC
POWER
O/B
RH JUMPER REMOVED. EIM POWERED BY A SEPARATE TRANSFORMER.
IF USING AN AC112-01 OR EQUIVALENT SLAB SENSOR FOR THE ZONE CONTROLLED BY THE THERMOSTAT, WIRE
THAT TO ANY OF THE 4 SETS OF S TERMINALS ON EIM AND MAKE SURE THE ISE SETTINGS MATCH THE WIRING.
1
2
120
VAC
1
TRANSFORMER
24
VAC
R (T)
HOT WATER
RELAY PANEL
ZONE 1
W (T)
2
M39211
R
C
AUX1
AUX2
24 VAC TO
THERMOSTAT
THM04R3000
Y2
G
L
W1
W2
W3
Y1
RH
RC
R
C
24 VAC
POWER
O/B
HZ432
R TO Rc JUMPER REMOVED IF EIM IS POWERED BY A SEPARATE TRANSFORMER.
ZONE 4 IS SHOWN IN THIS DRAWING. THE EIM CAN WIRE TO ANY ZONE ON THE TRUEZONE PANEL.
DOTTED LINES FOR MUTLISTAGE ONLY.
WIRE THE DAMPERS, TRANSFOMER AND HVAC TO ZONE PANEL AS SHOWN IN ZONE PANEL INSTALLATION GUIDE.
IT IS NOT RECOMMENDED TO USE A DISCHARGE SENSOR WITH THE EIM ON A ZONED SYSTEM. A DISCHARGE
SENSOR CAN BE WIRED TO THE ZONE PANEL FOR HIGH AND LOW LIMIT TEMPERATURE PROTECTION.
1
2
3
M39212
2
1
4
5
M1
M4
M6
R
C
W1/E
W2
W3
Y1
Y2
G
O/B
L
ZONE 4
DAMPER
THERMOSTAT
4
5
3