1 - 13
and then set the time-out duration (from 0-3000 seconds) by scanning digits on
the Programming Chart inside the back cover, then scanning Save.
Default = 0
sec (no alarm).
Note: If you are out of range when you scan a barcode, you will receive an error
beep even if you do not have the alarm set. You receive the error beep
since the data could not be communicated to the base or the host.
Alarm Sound Type
If you have set the out-of-range alarm enabled, you may change the alarm type
for the image scanner or base by scanning the appropriate barcode below and
then scanning a digit (0-7) barcode and the Save barcode on the Programming
Chart inside the back cover of this manual.
Default = 0.
Set the sound type to fit
your application.
Data Accumulation Mode
Scan the barcodes below to turn data accumulation (batch) mode on and off. If
data accumulation mode is on, barcode data is stored when the image scanner
is out of range of the base and transmitted once the image scanner is back in
range.
Base Alarm Duration
Image Scanner Alarm
Base Alarm Type
Image Scanner Alarm Type
Data Accumulation Mode On
* Data Accumulation Mode Off
To Next Page
Loading...
Need help?
General
Weight and Dimensions
