118 8680i User Guide
UPC-E0 Addenda Required
When Required is scanned, the 8680i only reads UPC-E bar codes that have
addenda. Default = Not Required.
Addenda Timeout
You can set a time during which the 8680i looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for UPC-E0 Addenda Required. Set the length
(in milliseconds) for this timeout by scanning the bar code below, then setting the
timeout (from 0-120 milliseconds) by scanning digits, then the Save bar code from
the Programming Chart on page 235. Default = 500.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
UPC-E0 Addenda Separator
When this feature is On, there is a space between the data from the bar code and
the data from the addenda. When turned Off, there is no space. Default = On.
To Next Page
Loading...
