Honeywell 900U02-0100 - Page 14

xiv ControlEdge HC900 Process & Safety Controller User and Installation Manual Revision 10
May 2019
Figure 100 – Modes of operation on RSM ............................................................................................ 174
Figure 101 – Lead/Controller synchronization ...................................................................................... 176
Figure 102 – LED Indicators on Controller CPUs (See Table 28)Table 28 – LED Indications on
Controller CPUs ............................................................................................................................. 180
Figure 103 – LED Indicators on Scanners—1 port (left), 2 port (right) ................................................ 190
Figure 104 – I/O Module LED indicators .............................................................................................. 195
Figure 105 – Terminal Board Connections for AI Calibration .............................................................. 202
Figure 106 – Terminal board Connections for AO Calibration ............................................................. 203
Figure 106 – Battery Life in Months ..................................................................................................... 211
Figure 107 – Extended Distance Example #1 ........................................................................................ 218
Figure 108 – Extended Distance Example #2 ........................................................................................ 219
Figure 109 – Example installation (not shown: 2
nd
RTP & cable for high capacity AI/DI/DO) ........... 221
Figure 110 – Analog input terminals ..................................................................................................... 224
Figure 111 – Two–wire transmitter connections with common 24 VDC supply .................................. 224
Figure 112 – Milliamp input connections with 250 ohm shunt resistance............................................. 225
Figure 113 – Volt, millivolt input connections ...................................................................................... 225
Figure 114 – Three-wire RTD input connections .................................................................................. 226
Figure 115 – Two-wire RTD or ohm input connections ........................................................................ 226
Figure 116 – Slidewire feedback connections for actuators .................................................................. 226
Figure 117 - Voltage input connections ................................................................................................. 250
Figure 118 - Current connections with 2-wire transmitter ..................................................................... 251