Honeywell BW MaxXT II User Manual

11. Force Calibration Enabled (optional)
If the Force Calibration option is enabled in Safety Suite Device Configurator (SSDC) and
a sensor is past due, the sensor(s) must be calibrated to continue and enter normal
operation.
Press to acknowledge. Refer to See "Calibration Procedure" on page74 for
more information. to begin calibration. If is not pressed to enter calibration
within 2 minutes, the detector automatically deactivates.
12. Cal IR Lock Enabled (optional)
If the Cal IR Lock option is enabled in Safety Suite Device Configurator (SSDC), the
following screen displays.
If IR LOCK ENABLED is enabled, the sensor(s) must be calibrated using the IRLink or
an IntelliDoX docking station.
For more information, refer to See "Device Configuration" on page28 for more
information. in User Options.
13. Bump Test
Note: BW Technologies by Honeywell recommends to bump test the sensors before each
day’s use to confirm their ability to respond to gas by exposing the detector to a gas
concentration that exceeds the alarm setpoints.
If Previous Bump Failed
If the last bump test performed was unsuccessful, the following screens display.
BW MaxXT II 23 User Manual

Honeywell BW MaxXT II Specifications

General

Brand	Honeywell
Model	BW MaxXT II
Category	Gas Detectors
Language	English