MasterLink
Error Codes
Issue/Error Log
Troubleshooting Recom-
mendations
177 Configuration checksum fail
Configuration Flash Checksum
Error.
1. If this Diagnostic Log is
recurrent then Config B
memory is treated as cor-
rupted.
2. In case of multiple occur-
rences, perform Factory
defaults.
3. And if it still persists,
replace the hardware.
-
Configuration parameters change
event
C
Event logged when configuration
parameters get changed and
logged into Flash.
- Power supply change event. C
Event logged when power supply
type gets changed.
For example:
a. 0 Dual Battery Pack or
b. 1 External Supply
- Magnetic swipe trigger event. C
Event logged when magnetic
swipe detected.
- Factory reset event. C
Event logged when factory reset
detected at power up through
default switch.
-
Advance low battery capacity indic-
ation.
C
Event logged when advance low
battery detected based on user
configuration in i3006.
- Network registration fail. C
Radio could not register with net-
work.
Check SIM and antenna.
-
Event when remote host connects to
CL.
C Host connected during calling.
- Remote host connected/disconnected. C
Host connected/disconnected
during callout window or con-
tinuous server mode.
- Callin start time. C
- Callin stop time. C
- Callout Start/stop time. C
- Firmware upgrade in progress. C Firmware upgrade in progress.
To Next Page
Loading...