MasterLink
Error Codes
Issue/Error Log
Troubleshooting Recom-
mendations
- FOTA in progress. C
Radio Firmware Over The Air
upgrade in progress.
- FOTA completed. C
Radio Firmware Over The Air
upgrade completed.
- Firmware upgrade start event. C
- Firmware upgrade successful event. C
- Firmware upgrade failed event. C
-
OTA Firmware upgrade image size too
high.
F
Size supported is < 1MB.
Check firmware size.
-
OTA firmware upgrade sequence mis-
match.
F
Firmware packet sequence mis-
match.
Start again to resume firmware
upgrade.
-
OTA firmware upgrade application
image checksum error.
F
167 ADC inputs error. B Issue with internal ADC.
168 Temperature measurement error. B
Error in measurement of internal
temperature of device.
171
External Data Flash Segment erase
fail.
B
Flash failure. Power Cycle the
unit if the problem persists even
after reboot replace the device.
173 Data Flash write failure. B
Flash failure.
Power Cycle the unit if the prob-
lem persists even after reboot
replace the device
174 OTA Flash write failure. B
Flash failure.
Power Cycle the unit if the prob-
lem persists even after reboot
replace the device.
175 Data Flash Read failure. B
Flash failure.
Power Cycle the unit if the prob-
lem persists even after reboot
replace the device.
176 OTA Flash Read failure. B
Flash failure.
Power Cycle the unit if the prob-
lem persists even after reboot
replace the device.
To Next Page
Loading...