STRYKER CVAHU ZIO CONFIGURATION GUIDE
32
Figure 48: Parameter Wm Config Cntr Sp
CNTR SP: Displays and allows modification of centre
setpoint as FALS, TRUE, UNDEFINED. This
parameter defines whether centre Setpoint is to be
used or not.
Default configuration: UNDEFINED
Configuration settings in program are as follows:
0 = FALS, 1 = TRUE, 255 = UNDEFINED
Figure 49: Parameter Wm Config Cntsp Hi
CNTSP HI: Displays and allows modification of centre
setpoint high limit. Its value ranges from CNTSP LO
to +100.
Figure 50: Parameter Wm Config Cntsp Lo
CNTSP LO: I Displays and allows modification of
centre setpoint low limit. Its value ranges from –10 to
CNTSP HI.
Figure 51: Parameter Wm Config Byps Min
BYPS MIN: Displays and allows modification of wall
module bypass time setpoint in minutes. Its value
ranges from 0 to 1092.
To Next Page
Loading...
