Honeywell CUL6438SR-CV1 - Tenant Mode Override; Override Functionality; Canceling Override

STRYKER CVAHU ZIO CONFIGURATION GUIDE
56
Override
Override allows the tenant to override the occupancy
settings (see Figure 104)
Figure 104: Tenant Override
Description: Override is used to make CVAHU ON
before or after occupied schedule or time. Override
remaining displays duration left (in hours and
minutes) for the override.
For example, if occupied duration is 9:00 AM to 6:00
PM and override operation is configured for one hour,
and if override is applied at 6 PM then override
remaining will be 25 minutes at 6:35 PM.
 Depending on the occupancy/override
configuration click the OVERRIDE soft key. The,
occupancy icon changes to one of the following
three modes:
o Standby
o Occupied
o Unoccupied
 If an override is set by the tenant, the OVERRIDE
soft key changes to CANCEL OVERRIDE.
 Click the CANCEL OVERRIDE soft key to cancel
the override.