STRYKER CVAHU ZIO CONFIGURATION GUIDE
54
Tenant Mode:
Introduction
The tenant, using the soft keys and arrow keys, may
change following features if these are configured.
1. Setpoints
2. Fan speed
3. System mode (heat/cool)
4. Initiate override
The tenant can change the Occupancy
Override parameter to Occupied,
Unoccupied, or Standby. And, the override
can be timed in minutes, days, or be
continuous.
Tenant Mode: View
Steps
Tenant mode default home screen is as shown
Figure 100 for reference.
Figure 100: Tenant mode home screen
HOME SCREEN label: ROOMTEMP
Description: Displays system status and room
temperature.
By referring to Figure 100, Tenant mode home
screen, has the following three soft keys. They
provide the following options which are explained
below in detail:
1. Fan
2. Override
3. System and view mode
Note:
Tenant mode default home screen may
be in any one of out of above mentioned
four home screen set by the contractor.
Refer Set Home Screen
Note:
1. The fan and override settings are optional
for home screen setup.
2. If the system command option is not
enabled, then the SYSTEM soft key does
not display on the tenant’s home screen.
3. If there are no parameters configured for
tenant’s access, the VIEW MORE soft key
does not display on the tenant’s home
screen
Note:
Following parameters/home screen’s in
Tenant view/adjust mode are for
reference only and may change as per
configuration done in contractor mode.
To Next Page
Loading...
