Controller Information
2-8 SVP Controller Operation Manual Part No.: 44200004 - Revision 2
of the prover although caution must be used if changing the Motor
parameters or the Sensor Pair. Changing of the Sensor Pair is only
applicable if you have the optional third optical switch installed.
Changing of the Motor parameters should only be done after consultation
with Honeywell Enraf experts as damage to the drive end could occur; the
Motor parameters are set at the factory for the specific model of your prover.
When the device is locked, the following configuration parameters
cannot be changed via the LAD menu until the user unlocks the
controller again.
>>Device
1. Identification
Site Name
Device Name
2. Units
Units of volume
3. Display
Display brightness
Display Contrast
Session time out value
4. Time
Date display format
Time display format
Date
Time
5. Motor
Motor switch timeout
Motor off delay
6. Sensor Pair
7. Volume
Total volume
Upstream volume
Downstream volume
>> I/O Setting
1. Output
Alarm Relay output
>> Alarm
1. Service due reminder
Alarm action
2. Machine Fault
Alarm action
3. Cycle count Threshold
Cycle count
To Next Page
Loading...
