Honeywell Enraf - Prover Calibration; System Information; Figure 2-12: Prover Calibration; Figure 2-13: System Information

Controller Information
2-14 SVP Controller Operation Manual Part No.: 44200004 - Revision 2
2.3.7 Prover Calibration
The menu screens for Prover Calibration are shown in the diagram below
(Figure 2-12). See Chapter 4 for detailed calibration procedures.
Figure 2-12: Prover Calibration
2.3.8 System Information
The SVP Controller “About” box is showing important information about:
 The Device (SVP Controller)
 The individual boards (HMI, SVP and Option)
 The firmware versions
Figure 2-13: System Information
Within this screen identification information is shown of the following
device components:
 Device serial number
 Production date
 Serial number of each FlexConn board
 Hardware version of each FlexConn board
 Application firmware version of each FlexConn board
 Build information of the firmware of each FlexConn board
 Boot firmware information of the firmware of each FlexConn board