Operations
Part No.: 44200004 - Revision 2 SVP Controller Operation Manual 3-3
repeatedly while the liquid flows through the prover pushing the piston
towards the downstream side. This test will only run in the absence of
a Flow Computer run permissive signal; it will not be executed if the run
permissive has been asserted by a Flow Computer.
See Chapter 5 - Troubleshooting if an error status is indicated.
To exit this operating mode use the LAD to navigate to Main Menu/
Diagnostics/Prover Service Test/Exit Prover Test
Prover Status · Prover Test
Piston Parked Position
Motor Idle
Error Status No Error
Cycle 787
Stop Time 10-31-12 11:39:32 AM
Sweep Time 00:00:01:020
Press OK to enter menu Stop
3.4 Prover Calibration
The third operating mode of the controller is Prover Calibration and will be
described in more detail in the next chapter.
To Next Page
Loading...
