Honeywell Enraf - CHAPTER 4 CALIBRATION; 4.2 Static Leak Detection Procedure; 4.3 Volume Water Draw Calibration

Table of Contents
iv SVP Controller Operation Manual Part No.: 44200004 - Revision 2
2.3.6.2.4 Time ................................................2-12
2.3.6.2.5 Motor ...............................................2-12
2.3.6.2.6 Sensor Pair ..........................................2-12
2.3.6.3 I/O Settings ............................................2-13
2.3.6.3.1 Alarm Relay Output ....................................2-13
2.3.6.4 Alarms ................................................2-13
2.3.7 Prover Calibration ........................................2-14
2.3.8 System Information .......................................2-14
2.3.9 Logs ..................................................2-16
2.3.9.1 Transaction Logs .......................................2-16
2.3.9.1.1 Transaction information ................................2-17
2.3.9.2 Calibration Logs ........................................2-17
2.3.9.3 Alarm Logs ............................................2-17
2.3.10 Diagnostics ............................................2-18
2.3.11 Transfer ...............................................2-20
2.3.12 LAD Settings ...........................................2-21
CHAPTER 3 Operations ....................................................3-1
3.1 Operating Instructions ..........................................3-1
3.2 Meter Calibration ...............................................3-1
3.3 Prover Test ....................................................3-2
3.4 Prover Calibration ..............................................3-3
CHAPTER 4 Calibration ....................................................4-1
4.1 General ......................................................4-1
4.2 Static Leak Detection ...........................................4-1
4.3 Volume Water Draw .............................................4-4
4.4 Gravimetric Water Draw ........................................4-12
4.5 Calculations ..................................................4-19
CHAPTER 5 Troubleshooting ................................................5-1
5.1 Run Prover Test ................................................5-1
5.2 Error Messages ................................................5-1
5.2.1 Sensor out of sequence ....................................5-1
5.2.2 Motor time out ...........................................5-1
5.2.3 Sensor stuck .............................................5-2
5.2.4 Service due ..............................................5-2
5.3 Diagnostics ...................................................5-2
5.3.1 Dashboard ..............................................5-2