Configuring Video and Audio Settings
17
underexposure.
If Mode is set to Manual, set the Near Light and Far Light brightness levels. Drag the slider
left or right to decrease or increase the value. Click the – and + signs to make fine
adjustments.
If Mode is set to Zoom Priority, set the IR Correction level to correct focusing problems
caused by bright IR light.
Defog
To enable the defog function, set Mode to OFF, Manual, or Auto.
Auto
The defog function is enabled automatically when the scene is obscured by fog
or
haze.
Manual
The defog function is always enabled.
If Mode is set to Manual, do the following:
1. Set Intensity to Low, Medium, or High.
2. Set Airlight Mode to Auto or Manual.
Auto
The defog function is fine-tuned automatically
(recommended).
Manual
The defog function is fine-tuned by the user using
Click Save to apply the settings.
Managing Profiles
After you have configured the camera properties for each profile (Normal, Day, Night), you
can set the profile(s) that you want the system to use on the Setup
Camera Setup Profile
Management page.
Next to Profile Management, select Normal, Full Time, or Schedule. By default, the system
has the Day profile always enabled.
Normal
The Normal profile is always enabled.
Full Time The Day profile or Night profile is always enabled, depending on your selection.
Schedule
The system switches between the Day profile and Night profile. Drag the sliders
on
the left and right sides of the timeline to set the Night-to-Day and Day-to-
Night
switching times.
Click Save to apply the settings.
To Next Page
Loading...
Need help?
General
