Configuring Event Settings
47
check box. Email settings must be configured in Setup Network Setup SMTP
(Email). See
Configuring Email Settings on page 33.
9. To take a snapshot when a tampering event is detected, select the Snapshot check box.
Note
For the snapshot to be attached to the email notification, the
Attachment check box must be selected in Setup
Network Setup
SMTP (Email). See Configuring Email Settings on page 33.
10. Click Save to apply the settings.
Configuring Scene Change Events
You can configure scene change event settings on the Setup Onboard Video Analytics
Video Detection
Scene Change page.
To enable scene change detection:
1. Select the Enable check box.
2. Next to Alarm Period, click Setup. The Alarm Period window opens.
3. Set the days and times when you want the alarm function to be active, and then click Save.
4. To start recording video when a scene change event is detected, select the Record
check box.
5. In the Record Delay field, enter the number of seconds that the system will continue to
record video after a scene change event has ended. Enter a value between 10 and 300.
6. To generate an alarm output when a scene change event is detected, select the Alarm
Output check box and select the alarm output(s) to be activated.
7. In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after a scene change event has ended. Enter a value between
10 and 300.
8. To send an email notification when an alarm event is detected, select the Send Email
check box. Email settings must be configured in Setup
Network Setup SMTP
(Email). See
Configuring Email Settings on page 33.
To Next Page
Loading...
Need help?
General
