2MP/4MP Low Light WDR IP Camera User Guide
50
Configuring IVS Analysis Events
You can configure IVS analysis event settings on the Setup Onboard Video Analytics
IVS Analysis page.
To enable IVS Analysis:
1.
Select the check box of rules to be applied and set the rule type.
2.
Click Draw Rule to set up an area for people counting. You can move or resize the area
using
your mouse. To move the area, drag one of the sides. To resize the area, drag one of
the
corner handles.
3.
Click Draw Target to set up the target size. You can move or resize the area using
your
mouse. To move the area, drag one of the sides. To resize the area, drag one of the
corner
handles.
4.
Next to Alarm Period, click Setup. The Alarm Period window opens.
5.
Set the days and times when you want the alarm function to be active, and then click Save.
6.
In the Duration field, enter the number of seconds of duration. Enter a value between 6 and
3600
7.
To start recording video when an event is detected, select the Record check box.
8.
In the Record Delay field, enter the number of seconds that the system will continue to
record video after the event has ended. Enter a value between 10 and 300.
9.
To generate an alarm output when an event is detected, select the Alarm Output check
box and select the alarm output(s) to be activated.
10.
In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after the event has ended. Enter a value between 10 and 300.
11.
To send an email notification when an event is detected, select the Send Email check
box. Email settings must be configured in Setup Network Setup SMTP (Email). See
Configuring Email Settings on page 33.
12.
To take a snapshot when an event is detected, select the Snapshot check box.
To Next Page
Loading...
Need help?
General
