Honeywell Fire-Lite Alarms MS-9600UDLS - Wiring a Sounder Base; Wiring the W-GATE

FireLite SLC Wiring Manual — P/N 51309:R3 7/29/2019 57
Wiring a Sounder Base Intelligent Detector Bases and Wireless Gateway
9.6 Wiring a Sounder Base
Figure 9.4 shows typical wiring of the B200S, B200S-LF, B200SR, or B200SR-LF Sounder Base.
9.7 Wiring the W-GATE
+ -
+ -
+ -
s
lc
-
b
2
0
0
s
r
w
ir
e
.
w
m
f
Figure 9.4 Wiring of a B200S(R)/B200S(R)-LF Sounder Base
To next device
on SLC
SLC
Note: The “grid” pattern on the
sounder base has been removed
for illustration purposes only.
UL-Listed
24V Power
Supply
Optional Sounder
Interconnect
NOTE: For more detailed wiring on the sounder base, refer to the device’s installation instructions.
NOTE: The W-GATE, as part of the wireless network, has been tested for compliance with the Federal Communications Commission
(FCC) requirements of the United States Government. It has not been evaluated for use outside the USA. Use of this system outside the
USA is subject to local laws and rules to which this product may not conform. It is the sole responsibility of the user to determine if this
product may be legally used outside the USA.
NOTE: It is recommended to use the same wire gauge if there are multiple connections to the same terminal.