This copper network card is used to allow messages of status
and control data to pass between control panels and network
(or terminal) nodes in a networked fire system. The card must
be plugged into the backplane of each panel and node in a
dedicated slot. When it is plugged into the slot P8 on the
backplane the external cables must be connected to terminal
block P10, which is also located on the backplane.
The dual-in-line switches on the card are set to program the
address number and baud rate.
Connecting the Panels and Nodes
This network card can be installed in:
Vigilon or 34K Fire Panels
•
VIG1-V3+ or 34K1-V3+
•
VIG1-NET-V3+
•
VIG2-V3+
•
VIG2-NET-V3+
•
VIG3-V3+
•
VIG3-NET-V3+
•
VIG4-V3+
•
VIG4-NET -V3+
Vigilon or 34K Network (or Terminal) Node
•
VIG-NODE-V3+ or 34K-NODE-V3+
Specification
Overall size 128mm height x 100mm width
Node address range 1 to 31
Baud 2400, 9600, 19.2K and 38.4K
Operating voltage ±5V (RS485)
Terminations Terminal block P10 assuming
Network card is installed in
backplane slot P8
Cable Belden 9729 (example)
Weight 72g (approximate)
Operating
temperature
0°Cto45°C
Storage temperature
-10°Cto55°C
Relative humidity
(non condenscing)
up to 90%
Using the Copper Network card a maximum of up to 31 Control
panels and Network (Terminal) nodes can be connected in a
secure network loop, with up to 1.2Km cable distance between
panels/nodes dependent on cable type.
Copper Network Card (BS) 4188-789 issue 2_12/05 1
Installation instructions
Copper Network Card (BS)
(VIG/34K-NC-V3+) for BS5839 Vigilon or 34K Network
by Honeywell
P10
Connections for
Network card in
Socket P8 (Card 6)
BACKPLANE
Control Panel
or Network Node
1 23 456 78
0V -ve +ve 0V I -ve +ve I
P10
BACKPLANE
Control Panel
Network Node
Cable screen
Connections for
Network card in
Socket P8 (Card 6)
To Next
panel
or node
From
previous
panel
or node
No
connection
No
connection
1 23 456 78
0V -ve +ve 0V I -ve +ve I
The 0V connection
is as shown.
To Next Page
Loading...
