Honeywell Gent Viglion EN54 - Network Card Baud and Node Address Switches; Powering-Up the Network; How to Check a Network Map

Network Card baud and node address Switches
&
The copper network card is factory set for 38.4K baud with node address 4.
Node address Baud rate
8765432 1
64 off off off off off off off off 2400
1 on off off off off off on off 9600
2 off on off off off off off on 19.2K
3 on on off off off off on on 38.4K
4 off off on off off off
63 on on on on on on
Address Baud
- factory settings
Powering-up the Network
¨
Add one panel at a time starting from the network controller (Node 1) at side 1.
"
It can take a few minutes for the system map to update.
¨
For each panel powered-up the network controller will automatically try to establish communication with the
connected equipment.
¨
The network controller will display the status of the network as being started, secure or non-secure and from now on
will monitor and control the network communications.
¨
Use disable comms to isolate a panel from the rest of the network, ie it operates at the network card in an echo
mode, select Menu On/Off -> [Control] -> [Disable] -> [Comms] and enter the Network Card number 4.
How to check a Network map
¨
Using the Menu On/Off -> [Info] -> [Map] -> [NetMap] menu, enter the network card address, usually 4.
The display will provide a list in cabling order the addresses of panels in the networked system.
These are examples of different networks. The lowest address ‘1’ has been given to the network controller.
This example shows the network is not
secure
This example shows the network is
secure
Generic Commissioning instructions
68 4188-856_i2_12/06_Generic Vigilon (Compact + VA) Comms.
Vigilon Compact Network
12345678
On
Off
Component side
Map information for Network at card 10
Nodes on side 1
19765
Nodes on side 2
13
Map information for Network at card 10
Nodes on side 1
1976531
Nodes on side 2
1356791