Vigilon Compact Panel
The following procedures assume the fire alarm control panel is installed, with cables terminated at the backbox with the inner and
outer doors fitted.
These procedure assume the protective cover fitted over the Master control board inside in the backbox has been removed.
¨
Connect flying earth lead j from the back box to the inner door.
¨
If not already done remove the protective coverk fitted over the Master control board inside in the backbox.
¨
Connect the ribbon cable l from the Display KEYBOARD to socket on the Master Control Board (MCB). Secure
the ribbon cable to the side of the enclosure using the cable clamp provided.
Generic Commissioning instructions
24 4188-856_i2_12/06_Generic Vigilon (Compact + VA) Comms.
Vigilon Compact Panel
ESD Earth
Bonding point
Inner door
Cardboard cover protecting
the Master Control Board
and Loop Card
Plastic cover
protecting PSU
REMOVAL OF COVER
EXPOSES HIGH VOLTAGE
WARNING
Earth lead from
back box - inner door
Cover to protect PCB
display and keyboard
Warning
removal
of cover
exposes
live parts
Battery
bracket
Back box
Ribbon cable
and clamp
MAINS
SUPPLY
LOOP 1
END 1
LOOP 1
END 2
Master
alarms 1
Master
alarms 2
NET 1
END 2
NET 1
END 1
To Next Page
Loading...
