Table of Contents
Preface--------------------4
Associated documents ------------4
Conventions -----------------4
Preliminary information ---------5
Safety information --------------5
Abbreviations ----------------5
Pre-visit checks----------------6
Points to remember --------------6
Informing responsible persons ---------7
Pre-commissioning --------------7
A typical commissioning process -----8
Product Approval and Standards -----9
Fire detection and alarm control panel -----9
S-Quad Sensors ---------------9
34xxx Sensors ----------------10
Sounder Strobe ---------------10
Interface Units ----------------10
Panel Controls and indications ------11
Vigilon Compact Panel ------------11
Vigilon Compact VA panel ----------11
Vigilon 4-loop panels (BS panel shown) ----11
Controls and indications ---------12
new Vigilon 4/6 loop Panels -------16
Second fix parts supplied -----------16
Remove the protective covers ---------17
Fitting the inner door -------------17
Printer paper roll ---------------18
Setting the DKC card -------------18
Card installation ---------------18
Terminals ------------------19
Before power-up ---------------20
Mains supply ----------------20
Battery installation --------------21
PSU LED indications -------------22
Write protect link on backplane --------22
EN panel factory settings -----------22
How to configure the 'U' buttons and
CB254 LED -----------------23
How to fit the outer door -----------23
Vigilon Compact Panel ---------24
Installing the cards --------------25
Wiring of external circuits-----------27
Battery connection --------------28
Switching the essential controls --------28
Factory settings----------------28
Power up-------------------28
How to configure the monitored input -----30
How to configure the buttons U1 and U2 ----30
How to configure LEDs CB253 and CB254 - - 30
External printer ----------------31
Vigilon Compact Voice Alarm Panel - - - 32
Cards and Terminals -------------33
Master Control Board Terminals--------34
Terminals on Audio Control Card (ACC) - - - 34
Factory settings----------------35
Loop Processor Card (LPC) ----------35
Power up-------------------36
External printer ----------------37
How to configure the monitored input -----37
How to configure the buttons U1 and U2 ----37
How to configure LEDs CB253 and CB254 - - 37
How to check and set the audio signal -----37
Indications on power up ---------38
Initial tests ---------------38
Useful menu options -----------39
Panel Buzzer-----------------39
Software version ---------------39
Password or
Personal Identification Number------39
How to set up the Engineer password -----40
How to set up a Customer password ------40
Address allocation ------------41
Connecting Loop 1 circuit-----------41
With Loop 1 End 1 connected ---------41
How to re-allocate a loop circuit --------42
Checking a loop map-----------43
To find devices on loop circuit --------43
Non Volatile Memory (NVM) ------44
Hardware write protect ------------44
The configuration data held at the panel ----44
Data Back-up & Recovery --------45
To back up loop data to NVM ---------45
To recover loop data from NVM -------45
To 'software' write protect NVM -------45
To 'software' write unprotect NVM ------45
How to electrically erase the NVM ------45
Safe Addressing -------------46
To safe address a device -----------46
To convert from safe to soft address ------46
Loop circuit tests ------------47
Loop resistance and capacitance --------47
How to [Repair] a loop circuit ---------47
Loop short circuit test -------------47
Ground break test---------------48
Positive line break test ------------48
Earth fault test ----------------49
Checking device status ----------50
Device checks --------------51
Checking the time averages ----------51
Checking the sensor Exceptions/Subfault codes 52
Exception codes for Optical (heat) (sounder)
sensor -------------------- 53
Exception codes for Heat sensor --------54
Exception codes for Beam sensor -------55
Exception (or Condition) Codes for S-Quads - - 56
Pre Fire, Fire and Super fire -------57
Device States --------------58
Generic Commissioning instructions
2 4188-856_i2_12/06_Generic Vigilon (Compact + VA) Comms.
To Next Page
Loading...
