Honeywell 60 Series IP Camera Software Configuration Guide
10
3 Logging In and Viewing Live
Video
This chapter contains the following sections:
• Logging In to the Camera via the Web Client, page 10
• Using the Main Page, page 14
Logging In to the Camera via the Web Client
Using the web client, you can monitor live video, play back recorded video, and configure
camera settings.
Before You Begin
Before you log in to the web client, ensure that the following conditions are met:
•
The camera is properly connected to the network.
•
The camera’s IP address and the PC’s IP address are in the same network segment. If
there is a router, set the corresponding gateway and subnet mask.
•
A network connection has been established. To check this, ping the camera’s IP address.
(Enter "ping [IP address]").
Logging in to the Camera
Logging in via Internet Explorer
1.
Open Internet Explorer, type the camera’s IP address in the address bar, and then click
Enter. For example, if your camera’s IP address is 192.168.1.108, you would type
https://192.168.1.108
.
Note Internet Explorer 11 with ActiveX plug-in is supported.
2.
The following window is displayed. Click Continue to this website (not recommended).
To Next Page
Loading...
Need help?
General
