Configuring Camera Settings
27
• G.711 provides good sound quality and requires about 64Kbps. Select pcmu (μ-Law) or
pcma (A-Law) mode.
• G.726 is a speech codec standard covering voice transmission at rates of 16, 24, 32, and
40kbit/s.
After you complete the settings on this page, click SAVE to enable the settings.
Configuring IR Control Settings
Go to Setup Camera SetupIR Control.
On this page, you can turn on the IR illuminator and adjust the luminance of IR lights.
Figure 4-7 IR Control Settings
IR Illuminators
Turn on built-in IR illuminator in night mode: Check to turn on the camera’s onboard IR
illuminator when the camera detects low light condition and enters the night mode.
Turn on external illuminator in night mode: Check the connector type to turn on the
camera’s external IR illuminator when the camera detects low light condition and enters the
night mode. You should connect an alarm output first.
Note
The built-in IR illuminator function is not applicable for
HC60WZ2E30.
Smart IR
Anti-overexposure: When checked, the camera automatically adjusts the shutter speed, Gain
and IRIS through algorithm of the firmware in order to avoid over-exposure in the night mode.
To Next Page
Loading...
Need help?
General
