Honeywell 60 Series IP Camera Software Configuration Guide
66
• Add date and time suffix to the file name
Select this option to add a date/time suffix to the file name.
Click SAVE MEDIA to enable the settings. The new media server will be automatically
displayed in the Media list. If you wish to add more media options, click ADD MEDIA.
Media type - Video clip
Select to send video clips when a trigger is activated.
• Media name: Enter a name for the media setting.
• Source: Select a video stream as the source of video clip.
• Pre-event recording
The camera has a buffer to temporarily hold data up to a certain limit. Enter a number to
decide the duration of recording before a trigger is activated. Up to 9 seconds can be set.
• Maximum duration
Specify the maximum recording duration in seconds. The duration can be up to 10
seconds.
For example, if pre-event recording is set to five seconds and the maximum duration is set
to ten seconds, the camera continues to record for another 4 seconds after a trigger is
activated.
• Maximum file size
Specify the maximum file size allowed. Some users may need to stitch the video clips
together when searching and packing up forensic evidence.
• File name prefix
Enter the text that will be appended to the front of the file name.
Click SAVE MEDIA to enable the settings.
Media type - System log
Select to send a system log when a trigger is activated.
Click SAVE MEDIA to enable the settings, and then click CLOSE to exit the page.
In the Event settings tab, the Servers and Medias you configured will be listed. Make sure the
Event Status is set to ON, in order to enable the event triggering action.
When completed, click SAVE EVENT to enable the settings and click CLOSE to exit Event
Settings page. The new Event / Server settings / Media will be displayed in the event drop-
down list on the Event setting page.
See the example of the Event setting page below:
To Next Page
Loading...
Need help?
General
