1 - 5
Return to Factory Default Settings
Important: After scanning the engine-specific bar code to return the imager to factory default settings, the next step is to open
the bar code wedge panel on the mobile device collecting the scanned data. Click the OK button to close the panel. This action
will synchronize all bar code reader formats for your device.
Cleaning the Beam Aperture
Note: New devices -- Remove the shipping film from the beam aperture before first use.
Keep fingers and rough, sharp or abrasive objects away from the beam aperture.
If the aperture becomes soiled or smudged, clean only with a standard household cleaner such as Windex® without vinegar or
use Isopropyl Alcohol. Dampen the cloth with the cleaner; do not apply liquids directly to the aperture.
Do not use paper towels or harsh-chemical-based cleaning fluids since they may result in damage to the aperture surface.
Use a clean, damp, lint-free cloth. Do not scrub optical surfaces.
If possible, clean only those areas which are soiled.
Lint/particulates can be removed with clean, filtered canned air.
To Next Page
Loading...
Need help?
General