Honeywell Marathon - Boot up Event; Parameter Event

2 - 16
Boot Up Event
When enabled, the decoder generates a message to the host whenever power is applied. When disabled, no notification is
sent.
Parameter Event
When enabled, the decoder generates a message to the host when one of the events specified below occurs. When
disabled, no notification is sent.
Enable Boot Up Event
* Disable Boot Up Event
Enable Parameter Event
* Disable Parameter Event
Event Class Event Code Reported
Decode Event Non parameter decode 0x01
Boot Up Event System power-up 0x03
Parameter Event Parameter entry error
Parameter stored
Defaults set (and parameter event is enabled by default)
Number expected
0x07
0x08
0x0A
0x0F