Honeywell Marathon - Code 39; Trioptic Code 39

2 - 43
Code 39
Note: This parameter must be enabled when “Convert Code 39 to Code 32” is to be enabled.
Set this parameter by scanning either of the bar codes shown below.
Trioptic Code 39
Trioptic Code 39 symbols always contain six characters.
When Trioptic Code 39 is enabled, set the Code 39 Full ASCII parameter to disabled.
Both parameters should not be
enabled simultaneously.
Set this parameter by scanning either of the bar codes shown below.
* Enable Code 39
Disable Code 39
Enable Trioptic Code 39
* Disable Trioptic Code 39