2 - 12
Picklist Mode
Picklist mode enables the decoder to decode only bar codes that are aligned under the laser crosshair. Select one of the
following picklist modes for the decoder:
• Disabled Always - Picklist mode is always disabled.
• Enabled Always - Picklist mode is always enabled.
Power Mode
Note: The Marathon is designed to be operated in Low Power Mode. Honeywell recommends leaving this value unchanged.
A parameter setting of Continuous On means the laser will not power down until the mobile device is powered off.
A parameter setting of Low Power means the laser will enter low power consumption mode after each decode attempt.
Pressing the Scan button will begin another decode sequence.
See Also: Time Delay to Low Power Mode.
Select a Power Mode by scanning either of the bar codes shown below.
* Disabled Always
Enabled Always
Continuous On
* Low Power
To Next Page
Loading...
