Honeywell Marathon Programming Guide

2 - 48
Code 93
Defaults =
• Disable Code 93
• L1 Parameter Default Value : 4
• L2 Parameter Default Value: 55
When enabled, Code 93 symbols will be scanned, decoded and transmitted.
Set this parameter by scanning either of the bar codes shown below.
Set Lengths for Code 93
Lengths for Code 93 may be set for:
• any length,
• one or two discrete lengths,
• or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains.
See the table titled “ASCII Character Equivalents”.
One Discrete Length (Parameter L1)
This option decodes only those codes containing a selected length. For example, when you want to scan only Code 93
symbols containing 14 characters, scan the “Code 93 One Discrete Length” bar code and then “1” and “4” bar codes
using the “Imager Keypad Number Symbols”. Default = 4.
To begin setting one discrete length, scan this Code 93 One Discrete Length bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero.
To correct an error or to change a selection, scan Cancel on the “Imager Keypad Number Symbols” page.
Enable Code 93
* Disable Code 93

Honeywell Marathon Specifications

General

Category	Handhelds
Manufacturer	Honeywell
Touchscreen	Yes
Wireless LAN	802.11b/g
Memory	128 MB RAM
Display Type	Color TFT
Bluetooth	Bluetooth 2.0
Expansion Slots	SD Card Slot
Operating Temperature	-10°C to 50°C
Display	Color TFT