2 - 30
Decode UPC/EAN/JAN Supplementals
Supplementals are bar codes appended according to specific format conventions (e.g., UPC A+2, UPC E+2, EAN 13+2).
The following options are available:
If one of the following Supplemental Mode options is selected, the bar code reader immediately transmits EAN-13 bar
codes starting with that prefix that have supplemental characters. If the symbol does not have a supplemental, the bar code
reader must decode the bar code the number of times set via "UPC/EAN/JAN Supplemental Redundancy" before
transmitting its data to confirm that there is no supplemental. The bar code reader transmits UPC/EAN bar codes that do
not have that prefix immediately.
Note: In order to minimize the risk of invalid data transmission, Honeywell recommends selecting whether to read or ignore
supplemental characters.
Option Result
Decode UPC/EAN/JAN Only with
Supplementals
The bar code reader only decodes UPC/EAN symbols with supplemental
characters, and ignores symbols without supplementals.
Ignore Supplementals The bar code reader decodes UPC/EAN and ignores the supplemental
characters.
Autodiscriminate UPC/EAN/JAN
Supplementals
The bar code reader decodes UPC/EAN symbols with supplemental
characters immediately. If the symbol does not have a supplemental, the
bar code reader must decode the bar code the number of times set via
"UPC/EAN/JAN Supplemental Redundancy" before transmitting its data
to confirm that there is no supplemental.
Option Result
Enable 378/379 Supplemental Mode ---
Enable 978/979 Supplemental Mode If 978 Supplemental Mode is selected and the decoder is scanning
Bookland EAN bar codes, see "Enable/Disable Bookland EAN" to enable
Bookland EAN, and select a format using "Bookland ISBN Format".
Enable 977 Supplemental Mode ---
Enable 414/419/434/439 Supplemental
Mode
---
Enable 491 Supplemental Mode ---
Enable Smart Supplemental Mode Applies to EAN-13 bar codes starting with any prefix listed previously.
Supplemental User-Programmable Type 1 Applies to EAN-13 bar codes starting with a 3-digit user-defined prefix.
Set this 3-digit prefix using Supplemental User-Programmable 1.
Supplemental User-Programmable Type 1
and 2
Applies to EAN-13 bar codes starting with either of two 3-digit user-
defined prefixes. Set the 3-digit prefixes using Supplemental User-
Programmable 1 and Supplemental User-Programmable 2.
Smart Supplemental Plus User-
Programmable 1
Applies to EAN-13 bar codes starting with any prefix listed previously or
the user-defined prefix set using Supplemental User-Programmable 1.
Smart Supplemental Plus User-
Programmable 1 and 2
Applies to EAN-13 bar codes starting with any prefix listed previously or
one of the two user-defined prefixes set using Supplemental User-
Programmable 1 and Supplemental User-Programmable 2.
Supplemental User-Programmable 1 Select Supplemental User-Programmable 1 to set a 3-digit prefix. Then
select the 3 digits using the Imager Keypad Number Symbols .
Supplemental User-Programmable 2 Select Supplemental User-Programmable 2 to set a second 3-digit prefix.
Then select the 3 digits using the Imager Keypad Number Symbols .
To Next Page
Loading...
