To Next Page

To Previous Page

2 - 49

Two Discrete Lengths (Parameter L2)

This option decodes only those codes containing two selected lengths. For example, when you want to scan only Code

93 symbols containing 2 or 14 characters, scan the “Code 93 Two Discrete Lengths” bar code and then “0”, “2”, “1” and

“4” bar codes using the “Imager Keypad Number Symbols”. Default = 55.

To begin setting two discrete lengths, scan this Code 93 Two Discrete Lengths bar code:

Next, scan four numeric bar codes that correspond to the desired value. Single digit numbers must have a leading

zero. To correct an error or to change a selection, scan Cancel on the “Imager Keypad Number Symbols” page.

Length Within Range

This option decodes a code type within a specified minimum and maximum range. For example, when you want to

scan only Code 93 symbols containing between 4 and 12 characters, scan the “Code 93 Length Within Range” bar

code and then “0”, “4”, “1” and “2” bar codes using the “Imager Keypad Number Symbols”.

To begin setting lengths within a range, scan this Code 93 Length Within Range bar code:

Next, scan numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero. To

correct an error or to change a selection, scan Cancel on the “Imager Keypad Number Symbols” page.

Any Length

This option decodes Code 93 bar codes containing any number of characters.

To set any length, scan this Code 93 Any Length bar code:

Honeywell Marathon Programming Guide

Other manuals for Honeywell Marathon